Epson 9300i - Manual (Page 75)

Fine-tuning the Projector 75
Customizing Projector Features
You can use the menu system to change the video signal input at
certain ports, turn on or off sleep mode, adjust the network settings,
change the language, and customize several other features.
Image Setup Options
Use these settings to change how the projector processes incoming
video signals. Several of these settings should normally be left at the
factory default setting (except for the Computer1, Computer2, and
BNC Input settings).
■ Computer1 Input (in the Setting menu)
Select the setting for the type of equipment you’ve connected to
the Computer 1 port:
Analog-RGB : For a computer connection
RGB-Video : For a video player that outputs an RGB video signal
■ Computer2 Input (in the Setting menu)
Select the setting for the type of equipment you’ve connected to
the Computer 2 port, as described above.
■ BNC Input (in the Setting menu)
Select the setting for the type of equipment you’ve connected to
the BNC port:
Analog-RGB : For a computer connection
RGB-Video : For a video player that outputs an RGB video signal
YCbCr : For a video player that outputs an NTSC signal
YPbPr : For a video player that outputs an HDTV signal
■ Video Signal (in the Video menu)
Leave this setting at Auto unless you are using a 60-hertz PAL
system (select PAL60 ). You can change this setting only if you’re
displaying an image through the Video or S-Video port.