Audio-Technica ATDM-0604a 6-Channel Digital SmartMixer - Manual (Page 13)

13
Using the product
Starting the product
1. Press the power button.
• The PRESET LED lights, blinks, and LEVEL·GAIN LED turns on. Then, the
PRESET LED turns off, and the product starts in operator mode.
2. The volume LED lights according to the IP Config Mode setting.
Front panel mode
The following two modes are available when operating the product
with the buttons and the dial on the front panel.
Operator mode:
In this mode, daily operations are performed, such as loading the preset settings
and adjusting the audio level.
Advanced mode:
In this mode, advanced settings can be configured by installing and implementing
the product on-site.
• When the power is turned on, the product usually starts in operator
mode. This prevents accidental device setting changes or other troubles,
and ensures a safe operation of the system.
Switch front panel mode
(operator mode/advanced mode/advanced mode)
Change between operator mode and advanced mode.
1. While pressing the MODE button, press and hold the dial button
(for 1 or more seconds).
2. LEDs light/blink/turn off, and the front panel mode changes.
• When changing to operator mode
(1) The LEVEL·GAIN LED and the PRESET LED light.
(2) The PRESET LED turns off.
(3) The front panel mode changes to operator mode.
• When changing to advanced mode
(1) The LEVEL·GAIN LED, the PRESET LED, and the LEDs from SIG/PK·MIC/
LINE to SIG/PK·PRESET SAVE become lit.
(2) All LEDs turn off except the LEVEL·GAIN LED, which blinks.
(3) The front panel mode changes to advanced mode.
Selecting a function
Press the MODE button, or turn the dial button while pressing the
MODE button, to select the function.
• Determine the function selected based on the LED that lights (LEVEL·GAIN
LED and PRESET LED, or an LED from SIG/PK·MIC/LINE to SIG/PK·PRESET
SAVE).
Functions available in operator mode
Functions available in advanced mode
Press the MODE button to change the function in the clockwise
direction as shown in the figure. While pressing the MODE button, turn
the dial button to change the function to the one in the direction of the
dial.
LEVEL
Start of function selection
PRESET
GAIN
PRESET
PRESET SAVE
AEC
ASSIGN
SMART MIX PRIORITY
LOW CUT
PHANTOM
MIC/LINE
LEVEL
Start of function selection
Auto Static