Audio-Technica ATDM-0604a 6-Channel Digital SmartMixer - Manual (Page 6)

6
Features
Features of ATDM-0604a
• 6 mic/line inputs and 1 unbalanced stereo input, implementing high-quality mic preamplifier with discrete amplifier
• Flip function allows switching between balanced and unbalanced outputs in stereo units. 1 unbalanced output can be output at microphone level
• USB audio I/O (1 stereo input and 1 stereo output)
• Built-in SmartMixer that allows for a selection between gain sharing and gate modes
• 6 microphone inputs with AEC for simultaneous use
• Simultaneous use with noise canceller (1 unit) possible
• 4-band EQ, comp/de-esser on each input, 12-band EQ on each output
• Comp and limiter on each input and output system. Pre/Post Fader selectable for each output
• 8-band feedback suppressors can be inserted into inputs and outputs (up to 8 units)
• Audio input/output settings can be configured on the front panel, whereas the advanced settings can be configured on a computer using Web
Remote.
• Allows for external control with IP Remote Protocol
• Up to one ES954 hanging array microphone (sold separately) can be connected to the microphone input
• Supports external muting of the ES954 hanging microphone from the mixer and can be set from a PC using the web remote
• Equipped with a ducking function
About Audio-Technica LINK
This product can daisy-chain up to eight ATDM-0604a units to support 48 mic/line inputs and 8 unbalanced stereo audio inputs for the entire
system. The proprietary Audio-Technica LINK functionality enables the transmission of low-latency, high-speed audio bus signals between devices,
making it possible to steadily control and transmit uncompressed audio signals.
Furthermore, the model offers excellent workability as it conforms to the Ethernet standards and can be connected to generic LAN cables (shielded
cables of Cat5e or above with the conductor diameter size of 24 AWG or larger must be used).
System installation
Installing on a rack
The product can be installed using the supplied rack-mount.
• When installing this product in a rack, ensure that the temperature inside the rack does not exceed 40°C. This will adversely affect the internal
components and cause malfunctions.
• Ensure at least a 10-centimeter space between the product and other devices or the top, side, and back faces of the rack.
• The required rack specifications are as follows.
– EIA-standard 19-inch rack
– 1U-size attachable rack
– Rack with a shelf on which the product is placed or a guide rail that supports the product
• The rack mounts are affixed to the product with the following screws. Check the following when using screws other than those supplied.
– S-tight (tapping screw), nominal diameter 4 × 6 mm