Audio-Technica ATDM-0604a 6-Channel Digital SmartMixer - Manual (Page 33)

33
Setting the audio input details
Setting the fader group
If a channel fader is set to the same group on this screen of the primary
or extension unit and assigned on p.46 on the operator's screen of the
primary unit, the fader assigned on that primary unit will be used to
control the levels of channels belonging to the same group.
1. Click the area in the red box on the screen shown below.
2. Select the fader group.
Setting the Min/Max Volume
Determine the Min/Max Volume and turn it ON/OFF for each channel.
1. Click the area in the red box on the screen shown below.
• The setting is turned ON (blue)/OFF (no color) each time the switch is
clicked.
• The fader minimum/maximum are set at the position when the Min/Max
Volume is turned ON. The range below and above the specified position
is grayed out. To change the position, turn the Max Volume OFF and then
back ON.