Canon CR-N700 4K PTZ Camera with 15x (Satin Black) - Manual (Page 23)

23
(Iris priority AE)
The iris is adjusted manually. The shutter speed and gain are adjusted automatically.
(Manual)
The exposure (shutter speed, gain, iris, etc.) is adjusted manually.
(Portrait)
Blurs the background to make the subject stand out.
(Sports)
Captures fast moving subjects.
(Low light)
Brightly captures subjects in dark locations.
(Spotlight)
Captures subjects illuminated by a spotlight beautifully.
Note
• The exposure settings (iris, shutter speed, gain, etc.) are automatically adjusted for Portrait, Sports, Low Light, and Spotlight. White
balance and image quality cannot be operated.
• In Portrait and Sports mode, the captured video may not appear smooth or may flicker.
• For precautions regarding shooting in Low Light, refer to “About Shooting with Slow Shutter” (P. 24).
[AE Shift]
When one of the [Shutter Mode], [Gain] and [Iris] is set to auto, the exposure can intentionally be compensated to capture
subjects either at a brighter or darker exposure. Move the slider knob or click or to change the value.
Note
In infrared shooting, [AE Shift] cannot be set.
[Shutter Mode]
Adjusting the shutter speed enables to adapt to the shooting environment, making it possible to capture fast-moving
subjects (sports, vehicles, etc.) clearly and brighten low-light scenes, etc. Shutter speed can be adjusted in the following
modes:
[Auto (sec.)]
Automatically adjusts the shutter speed according to the brightness of the video.
[Speed (sec.)]
Sets the shutter speed to seconds. The shutter speed can also be set to a value higher than the frame rate. Move the
slider knob or click or to change the value.
[Slow (sec.)]
Sets the shutter speed slower than the frame rate to seconds. This setting is used for shooting in low-light areas. Also,
special effects such as “blurring the background” and “adding residual image effects to zoom” are available for shooting
a moving subject with pan operation. Move the slider knob or click or to change the value. For precautions
regarding shooting, refer to “About Shooting with Slow Shutter” (P. 24).
[Clear Scan (Hz)]
Sets the shutter speed by frequency. This is used to reduce black bands on the screen, flickering from fluorescent
lighting, and to fine tune the brightness. Move the slider knob or click or to change the value.
[Angle (°)]
Sets the shutter speed at the open angle. Move the slider knob or click or to change the value.
[Off]
The reference shutter speed of each frame rate is used.
Note
When shooting in [Slow (sec.)], the focus may not work well in autofocus.