SmartSystem Matrix Sled Chimera (Gold Mount) - Manual (Page 13)

13
LONG pressing the gimbal thumb
button switches operating modes
from normal to friction, and back
again.
Normal mode simulates a
traditionally balanced Steadicam,
returning to a trimmed tilt angle.
Volt displays solid green LEDs.
Friction mode holds the sled tilt,
and requires force to change tilt
position, like a fluid head.
Volt displays pulsing green LEDs.
SHORT pressing the gimbal
thumb button creates a tilt trim
in normal mode.
Hold the sled at your desired
tilt angle, and short press the
button. The new trim is memorized
immediately. This can be done on
the fly, even during a shot, a huge
benefit to your operating.
WARNING: Use the Tiffen Padded Dock to protect Volt electronics, as well as make
docking and balancing easier. Other methods of docking may damage the unit!