SmartSystem Matrix Sled Chimera (Gold Mount) - Manual (Page 25)

25
R
einstalling the stage is easy, but remember to only use the provided high-strength screws. All twelve in
the clamp and stage connector are the same size and spec. Spares are available.
Align the stage connector’s red
mark with the post reference line,
and carefully press into place.
Tighten each screw a little bit,
in a criss-cross pattern, until all
are snug.
Align the center of the stage with
the red line on the post connector.
Press firmly until the stainless ring
is flush.
Install the six screws with a 7/64”
Allen wrench. Tighten with ample
torque to secure the stage.
Snug down the single clamp screw, and you’re ready
to get back out there!