SmartSystem Matrix Sled Chimera (Gold Mount) - Manual (Page 38)

38
Y
ou can easily move the monitor mount from the lower post to the gimbal post. While the mount is off
the post, you may also flip it over so the monitor will be upright in low-mode.
IMPORTANT: support the monitor with one hand while disengaging and engaging the clamp.
Open the clamp lever, and then
turn the lever counter clockwise
about 10 turns until it clears the
swing arm.
Pull the monitor away from the
post. The post clamp will swing
clear.
Reposition the monitor mount
on the other post, or flip it over
for low-mode. Close the clamp
around the post or post brake.
Close the clamp lever around the
clamp, and twist the lever about
10 turns back in, setting the clamp
tension you prefer.
Confirm the marks are lined up
with the reference line, so the
monitor is square to the rig, and
close the clamp lock.
NOTE: If you replace the monitor rods with your own 15mm rods, always use the
included thread-in stops to prevent the monitor from going AWOL.
Clamp operation