SmartSystem Matrix Sled Chimera (Gold Mount) - Manual (Page 14)

14
T
he three dials on the dial box allow you to customize the behavior of the Volt in two axes, roll and tilt,
independently. Additionally, the damping dial controls how the system returns the sled to vertical. Here
are some general guides to the three knobs.
The ROLL dial controls the
strength of the motors along the
roll axis. Start with low assist and
add strength as needed.
Damping works like friction to
keep the sled from oscillating. Use
as little as possible, in proportion
to your TILT strength.
The TILT dial controls the strength
of the motors along the tilt axis.
This alters behavior in the two
modes:
• In normal mode, more tilt
strength equates to stronger
artificial bottom-heaviness.
• In friction mode, more tilt
strength equates to firmer
hold at the operator’s set post
angle, like the drag on a fluid
head.
To set the ROLL trim, SHORT-press the trim button on the stage and
position the sled to the new level position while the LEDs blink for 5
seconds. When LED blinking stops, your new horizon position will be
stored in memory. Set independently for high or low modes
Reset the roll trim by long-pressing for more than 6 seconds. Previous
tilt trim is maintained.