Installing volt electronics – SmartSystem Matrix Sled Chimera (Gold Mount) User Manual
Page 18
T
he Volt electronics
are hidden inside the top stage, just beneath the dovetail clamp. All M-2 sleds are
pre-wired to easily upgrade to Volt. Factory installation is recommended, but it’s not too difficult.
CAUTION:
Take proper ESD protection when installing the Volt control board into the stage, and confirm
that no batteries are installed on the sled at time of installation.
Remove the eight hex screws
securing the dovetail clamp to the
top stage chassis. Carefully lift the
stage top STRAIGHT off.
Fasten the Volt brain to the stage
chassis with the four included
screws, one in each corner.
Replace the stage top STRAIGHT down onto the stage. DO NOT slide
the top into place, which may damage the VOLT electronics. DO NOT
pinch any cables, and ensure internal power cables can slide freely.
Finish by fastening the stage top with the eight hex screws.
Inside, you’ll find three cable sets with connectors that attach to the
Volt circuit board, the largest is at the front of the stage. Align the
circuit board as shown, and plug them in. Make sure each connector is
orientated properly, and be gentle!
NOTE:
There are buttons and jumpers on the Volt electronics for programming the board. DO NOT touch unless instructed to do so!
Installing Volt electronics