SmartSystem Matrix Sled Chimera (Gold Mount) - Manual (Page 26)

26
R
emoving or replacing the base is easier than the top stage, because there are fewer parts, and fewer of
those high-strength screws. The base connector is the same as the stage connector. For years of trouble
free use, don’t force anything, and keep them clean while separated.
To remove the base, start by
removing the monitor mount to
make it easy to access the screws.
Use a 9/64” Allen wrench to
remove the four screws from the
post connector.
Pull the post STRAIGHT up off the
base. It may take a firm pull, but do
not twist or force anything.
To reinstall the post on the base, align the flat spot
on the post connectors. The straight edge of the post
foot will align behind the electronics box of the base.
Insert firmly until the post connector
sits flush on the base and install the
four screws. Tighten with ample
torque to secure the post.