Inputs and outputs, Front electronics, Rear electronics – SmartSystem Matrix Sled Chimera (Gold Mount) User Manual
Page 7
Volt gimbal connector
LEMO® 8-pin 1B connector
Rotates 90˚ for cable routing
Included on ALL top stages
Front Electronics
Tally IN/OUT port
LEMO® 4-pin 0B connector
Use with available tally sensor
Triple 12/24V ports
LEMO®
3-pin 0B connectors
Outer port rotates 90˚
12 volts supplied at all times
12 and 24 volts simultaneously
when in 24V mode
Dual P-Tap ports
12 volts supplied at all times
Oriented for cable management
Self-resetting 5A fuse protected
Rear Electronics
Camera power port
LEMO® 3-pin 2B connector
12 volts supplied at all times
12 and 24 volts simultaneously
when in 24V mode
Triple HD video ports
HD-SDI compatible
Direct connections to the base
Color coded at each end
NOTES:
Tally sensitivity is set at maximum from the factory with active LO tally input signal, and this should work for most users.
Contact Tiffen service for instructions on adjusting tally sensitivity and setting to active HI, if required.
Also, there is a covered micro-USB port on the underside of the stage. This is ONLY for Volt firmware updates at the factory.
Inputs and outputs