Panasonic KX-TD500 - Manual (Page 176)

Line
176 Programming Guide
Parameter [DDI / DID / TIE] Digits to delete
Default 0
Value Range 0-16 digits
Description/Function Specifies the number of digits to be deleted from the number
received from the DDI / DID trunk / other PBX via TIE lines.
Reference • 1.5 Attended Features (F/G)
– Direct Inward Dialling (DID)
• 2.4 ISDN Attended Features (F/G)
– Direct Dialling In (DDI)
• 3.1 TIE Line Features (F/G)
– TIE Line Service
Parameter [DDI / DID / TIE] Number to be added
Default Blank
Value Range Max. 8 digits consisting of 0-9
Description/Function Specifies the number (1 to 8 digits) to be added to the number
received from the DDI / DID trunk / other PBX via TIE lines.
Reference • 1.5 Attended Features (F/G)
– Direct Inward Dialling (DID)
• 2.4 ISDN Attended Features (F/G)
– Direct Dialling In (DDI)
• 3.1 TIE Line Features (F/G)
– TIE Line Service
Parameter Digit to receive DDI / DID
Default 4 (DID / DID-2W / DID-MFC / E1[DR2] / T1[DID] card), 16 (BRI
/ PRI23 / PRI30 card)
Value Range 0-16 digits
Description/Function Specifies the number of digits received from a DDI / DID trunk.
(Assignable only when "Incoming Type" is set to "DDI" or "DID.")
Note
• In case of the following cards, a maximum number of digits
to be received is limited to 7 digits; DID, DID-2W, DID-
MFC, E1(DR2), T1(DID)
Reference • 1.5 Attended Features (F/G)
– Direct Inward Dialling (DID)
• 2.4 ISDN Attended Features (F/G)
– Direct Dialling In (DDI)