Panasonic KX-TD500 - Manual (Page 345)

Programming Error Messages
Programming Guide 345
E1059 VPS card duplicated.
Each physical number of the VPS Card (Jack 1-8) and VPS Card (Jack 9-12) must be
assigned uniquely.
E1060 You have exceeded the limit of VPS(DPT) port per DLC card.
There is a limit of 8 VPS(DPT) ports per DLC card.
E1061 You have exceeded the shelf limit of VPS(DPT) port.
There is a limit of 16 VPS(DPT) ports per shelf.
E2001 Invalid time format.
Please specify the time as Hour:[0]1-12, Minute:[0]0-59.
E2002 Assign the time of beginning and ending in a pair.
Cannot assign just the start time or just the end time of Lunch/Break service. Both must
be assigned as a pair.
E2005 Maximum entry number of System Speed Dialing exceeded.
The system provides up to 1000 / tenant, 2000 / system of System Speed Dialling
entries available to all extension users.
E2006 Cannot change System Speed Dialing Entries Maximum.
Please delete System Speed Dialling entries until there is less than the setting you want.
Then set System Speed Dialling Entries Maximum once again.
E2007 Invalid directory number for manager extension.
Only DN of an extension can be assigned as a manager extension. (FDN cannot be
assigned.)
E2008 Feature number is too long.
Feature numbers "Hundred Block Extension" or "Other PBX" can be set as the leading
1 or 2 digits of the extension number.
E2009 Cannot delete the Hundred Block Extension, which is currently in use as DN or
FDN.
Cannot delete the hundred block number. It's already used as DN or FDN. Please delete
the hundred block number after you remove the registrations of DN or FDN.
E2010 Feature number duplicated.
Feature numbers can be from 1 to 4 digits and shouldn't be any conflicts.
The following are examples of feature number conflicts.
Examples: N and NX, NXX / NM and NML ( NL is allowed.)
E2011 Out of range.
Overflow Timer should be assigned in the range of Second: 5-180.
"None" shows that Overflow Timer doesn't work.
E2012 Trunk group number duplicated.
Each trunk group in the Local Hunt Sequence must have a unique number.
Error Code
Error Message
Description