Panasonic KX-TD500 User Manual
Page 199
Line
Programming Guide
199
<Key Type Assignment>
The following Key Type Assignment screen is displayed by clicking "Key Type Display"
button (including "Not Stored") for each CO key on the above screen.
<Additional Parameters Required by Key Type>
Depending on a Key Type, additional parameters are required as follows.
Key Type
Additional
Parameters
(default)
Description
SINGLE-CO
Trunk Line No.
Specifies the trunk port physical number (10101 to 31416).
Tone (2)
Specifies the ringer frequency (ring tone type: 1-8) for
incoming calls.
GROUP-CO
Trunk Group No.
Specifies the Trunk Group number (01 - 48).
Tone (2)
Specifies the ringer frequency (ring tone type: 1-8) for
incoming calls.
LOOP-CO
Tone (2)
Specifies the ringer frequency (ring tone type: 1-8) for
incoming calls.
DSS
EXT.
Specifies the extension number ( 3 or 4 digits).
PHANTOM
EXT.
Specifies the phantom extension number ( 3 or 4 digits).
Ringing (Yes)
Specifies whether the extension rings or not when a call to a
phantom button comes in on the extension.
PDN
Tone (2)
Specifies the ringer frequency (ring tone type: 1 - 8) for
incoming calls.
Ringing Type
(Immediate)
Specifies the timing of ringing when a call comes in on the
extension: Immediate, 1-ring Delay, 3-ring Delay, 6-ring
Delay, No Ring