Panasonic KX-TD500 - Manual (Page 179)

Line
Programming Guide 179
Parameter [CPC Signal] OUT Detection
Default Enable: DID / DID-2W / DID-MFC / E1 [DR2] card, Disable:
ELCOT / GCOT / LCOT / PCOT / RCOT / T1 [GCO] / T1 [LCO]
card
Value Range 1. Enable
2. Disable
Description/Function Specifies whether CPC Detection on outgoing CO calls is enabled
or disabled.
If enabled, the system disconnects the line with the time set in
programme "[CPC Signal] OUT Detection - Detection Time" when
the CPC signal is detected.
Reference • 1.3 System Features (F/G)
— Calling Party Control (CPC) Signal Detection
Parameter [CPC Signal] OUT Detection - Detection Time (Type A)
Default 400 ms: [NZ], None: Others
Value Range 1. None
2. 6.5 ms
3. (2-75) 8 ms
Description/Function Specifies the expected minimum duration for detecting CPC
(Calling Party Control) signal on outgoing CO calls.
Type A applies to the following cards:
LCOT, ELCOT, GCOT, T1 [LCO], T1 [GCO], RCOT, PCOT
Reference • 1.3 System Features (F/G)
– Calling Party Control (CPC) Signal Detection
Parameter [CPC Signal] OUT Detection - Detection Time (Type B)
Default 160 ms
Value Range 1. None
2. (1-15) 80 ms
Description/Function Specifies the expected minimum duration for detecting CPC
(Calling Party Control) signal on outgoing CO calls.
Type B applies to the following cards:
E1 [DR2], DID-2W, DID-MFC
Reference • 1.3 System Features (F/G)
– Calling Party Control (CPC) Signal Detection