Panasonic KX-TD500 - Manual (Page 348)

Programming Error Messages
348 Programming Guide
E4024 DN or FDN must be entered to assign the type of key.
You must enter the DN or FDN when you assign key type "DSS," "Phantom," "SDN,"
"VTR," "2WAY-REC" and "2WAY-TRN." Each key needs following directory number
as DN or FDN:
- DSS
Extension directory number which is in existence.
- Phantom
Floating directory number which is registered in "5-2 Phantom Extension" screen.
- SDN
Primary directory number (PDN) of the DN mode extension.
- VTR, 2WAY-REC / TRN
Extension directory number which is assigned as VPS.
E4025 PHANTOM key duplicated.
Two phantom keys cannot have the same phantom FDN.
E4026 Please enter CO key number assigned to S-CO, G-CO, L-CO or SDN key.
The CO key number which is assigned to Single-CO, Group-CO, Loop-CO or SDN
key should be entered when "Prime Line - CO" is specified in "[Preferred Line]
Outgoing / Incoming" programming.
E4027 Doorphone destination duplicated.
Doorphone destinations (extensions) must be unique for Day mode settings and Night
mode settings. However, an extension used for Day can be used for Night.
E4028 Converted digits exceed the limit.
Total number of converted digits should be less than 16 digits.
Please change 'Digits to delete,' and/or 'Number to be added.'
E4029 Invalid directory number for G-LOGIN / LOGOUT key.
Only FDN of an Incoming Group can be assigned as the number of G-LOGIN /
LOGOUT key.
E4030 Invalid directory number for G-FWD key.
Only FDN of an Incoming Group can be assigned as the number of G-FWD key.
E5001 Assign both 'name' and 'number' for Caller ID.
Cannot assign just the name for Caller ID.
E5002 Cannot use more than seven % characters.
There can be a maximum of seven % characters in an absent message.
E5003 User code format error.
Please assign the DISA / TIE user code of 4–10 digits consisting of 0–9.
E5004 User code duplicated.
Each code in the DISA / TIE User Code must have a unique number.
E5005 Cannot set 'RET' command at the head.
Please set the command except for "RET" at the head of UCD Time Table.
Error Code
Error Message
Description