HP MSL6000 Series - Manual (Page 106)

Troubleshooting 106
200A Menu Mode • Take the library out of the Menu Mode
via the backspace using the LCD touch
display.
• Update the Map using the LCD touch
display. (Menu -> Maintenance -> Force
reconfiguration)
200C Cart Inaccessible
(For an SDLT drive, indicates the tape is
not in the unloaded state. For an Ultrium
drive, indicates the tape is not ejected.
Cartridge in drive is not accessible from
changer.)
• Invalid user initiated operation. Select
parameters correctly and try again.
• Ensure drive is powered on.
• Ensure the drive shows good status
through the drive status window.
• Check the tape cartridge used in the last
operation for damage.
• Reactivate drive using control panel
maintenance menu and reseat drive.
200D Drive In Error
(A general drive error detected by control
task)
• Cycle power to the library or reboot
using the GUI touch screen.
• Ensure the drive shows good status
through the drive status window.
• Reseat drive.
200E No Magazine
(Cannot move from changer. Element not
installed.)
• Press the Enter button to clear the
message.
• Invalid user initiated operation. Select
parameters correctly and try again.
• Check for magazine.
• Replace magazine.
200F Removal Prevented
(Receive medium prevent removal from
drive for a fetch.)
• Attempt to unload drive from software. If
fails, power off unit, disconnect from SCSI
bus, and retry operation.
• Invalid host initiated operation. Check
that application is certified to work with
your library and has up-to-date patches.
• Invalid user initiated operation. Select
parameters correctly and try again.
• Check for firmware tape in drive.
• Check for cleaning tape in drive.
• Press the Enter button to clear the
message.
Table 10 Fault Symptom Codes (continued)
FSC Message ERP