Applying power to the library – HP MSL6000 Series User Manual
Page 35
Advertising
MSL6000 series tape library user guide
35
Figure 16
Converting a rackmount model (two-drive model shown)
Applying Power to the Library
To apply power to the library (see
1.
Connect each supplied power cord X to each power supply receptacle.
NOTE:
For four-drive models only, the left-hand AC power receptacle is for the bottom power
supply. The right-hand AC receptacle is for the top power supply.
2.
Toggle each power switch Y on.
Advertising
This manual is related to the following products: