Measurement Specialties 9116 User Manual
Page 42
Pressure Systems, Inc. Model 9116 User’s Manual
Page 33
www.PressureSystems.com
Example:
●
Configure and start the Multi-Point Calibration function so that it affects only the first
four (4) channels of the module. Three (3) pressure calibration points will by supplied
when we continue this function later (see example for ‘01’ sub-command below). A
linear (1st order) fit will be used to obtain a new set of offset and gain correction
coefficients for these four (4) channels. The maximum average sample count (32) is
used to collect each calibration data point, so as to minimize any noise in the data
samples. The module’s data acquisition process is altered immediately to collect the
increased number of averages.
“C 00 F 3 1 32”
Read
response:
“A”