Muratec Fax Machine - Manual (Page 115)

Advanced fax
Autodialing while using the PIN mask
Note: The following instructions presume you understand how to set and use your
machine’s autodialer. If you need to review, see pages 3.11–3.23.
If you chose “Mode 1” — the PIN goes in
In Mode 1, before autodialing a number for the first time, you must add the PIN to
the stored one-touch key or speed-dial number. Here’s how:
1 Begin by creating or changing an entry in the
autodialer. (See pages 3.11–3.23, if necessary.)
While you’re setting this up, the machine asks
you to enter the
PIN . The LCD shows:
2 Select “PIN” and press [Enter].
3 Use the numeric keypad to enter the four-digit
passcode.
4 Press [Enter].
5 Use the numeric keypad to enter the desired
PIN , up to eight characters in length.
6 Press [Enter] to save the PIN .
Note: If you press [Enter] without entering
the PIN , the machine beeps, indicates “Invalid Number” on the LCD and
then returns to step 5.
Now you may autodial the number as usual.
Important: While in PIN Mode 1, any autodialer numbers you use must include
the PIN . This also applies to autodialer numbers used with batch
transmission (see pages 3.26–3.28) or programmable one-touch keys
(see pages 3.54–3.60).
Note: If you select either Mode 1 or Mode 2 and will be using batch transmission,
you must store the PIN access code for the remote unit within the appropri-
ate batch box. (See “Performing batch transmission while using the PIN
mask,” page 3.64.)
If you chose “Mode 2” — as you autodial, load the code
In this mode, you don’t have to add the PIN to the autodialer setting. Instead, you
enter the PIN manually each time you autodial:
1 Dial the number as you normally would, using the autodialer.
2 Use the numeric keypad to enter the PIN .
3 Press [Enter].
Your machine dials the number.
Note: If you select either Mode 1 or Mode 2 and will
be using batch transmission (see pages
3.26–3.28), you must store the
PIN access code for the remote unit within the
appropriate batch box. (See “Performing batch transmission while using the
PIN mask,” page 3.64.)
Dialing from the numeric keypad while using the PIN mask
If you’ve specified Mode 1 — use “star” power
1 Enter the phone number, then press the
* (“star”) key and enter the
PIN .
The PIN always goes last.
For example, to dial 19725550911 with a PIN of
“12345678”, enter 19725550911*12345678:
2 Press START . The PIN disappears from the dis-
play, and your machine dials the desired phone
number.
If you’ve specified Mode 2 — the machine guides you
1 Enter the phone number as usual.
2 Press START . The LCD shows:
3 Use the numeric keypad to enter the PIN .
4 Press [Enter].
Your machine dials the number.
3.63
F
ax F
eatures
Getting Started