Muratec Fax Machine - Manual (Page 82)

Advanced fax
4 Select the command you want to review or can-
cel using the cursor key. Then press [Location]
to see individual numbers within the broad-
cast.
5 The LCD shows:
Note: Press [Location] again to return to the
previous display.
6 Select the location you want to cancel using the
cursor key.
7 Press [Erase].
If you want to cancel a different location, repeat steps 6–7.
If you do not want to cancel any more locations, press
RESET . The machine
will return to standby mode.
Printing a delayed command list
Your machine can print a command list which tells you:
• The command’s identification number
• The phone number, or “remote location”
• The start time (this appears in a
DD , HH : MM format)
• A “note” telling if the command is a polling or F-Code operation (see pages
3.34–3.36 for more on polling and 3.44–3.53 for more on F-Code communication).
To print a delayed command list, press MENU , F , [List].
Printing a stored document
Your fax machine can print out each document stored for delayed transmission.
To print a stored document:
1 Press JOB REVIEW & COMM CANCEL .
2 Select “Reserved Transmission” and then press [Enter].
3 Select the command you want using the cursor key.
4 Press [PrintDoc]. Your machine will print a copy of the stored document.
View the result of fax transaction
You can see the 100 most recent fax transactions and result of each transactions
with the following information.
• Assigned number, starting each day at 001
• Remote location called (The destination name)
• Resolution mode
• Starting date and time
• Duration, in minutes and seconds
• Number of pages you sent or received
• Result of the call — If preceded by an asterisk (*), this signifies an
ECM commu-
nication. Or, if preceded by #, this signifies an super G3 communication.
1 Press JOB REVIEW & COMM CANCEL .
Note: If the number next to “Comm. Result”
displays “000”, it means there are no
reports in your machine.
2 Select “Comm. Result” and then press
[Enter]. The
LCD will show:
Note: Your machine’s LCD shortens the word
Transmission to Tx and the Reception
to Rx.
Note: The assigned number starting at 001 is
assigned separately between Tx and Rx.
3 If you want to see the detailed result of each
transaction, press [Detail].
The
LCD will show:
Press [Detail] again to return to the previous
display.
If you wish to exit this mode, press
RESET .
3.30