Muratec Fax Machine - Manual (Page 159)

Just in case
Occasionally, your machine encounters some trouble transmitting or receiving docu-
ments. When it does, it alerts you with an alarm. You can identify the problem with
LCD messages and printed check messages and error reports, explained in the follow-
ing pages.
Alarm
Your fax machine sounds an alarm tone — a series of short beeps — if either of
these two problems occur:
• Trouble transmitting or receiving
• The machine is out of paper
LCD error messages
If a message not listed here is displayed, take corrective action by following the
instructions in the message.
< Copy >
What you see on the LCD What it means/What to do
ADF is not When use the series copy function, the document is set in
available. the ADF . You cannot use the ADF for series copy.
Set document Remove the document from ADF , then set the document
on FBS glass on FBS glass.
Auto doc. size Non-standard size document is set. Your machine can
detection failed. detect Letter , Legal , Half-letter and
11 ″× 17 ″ (ledger ) sized document only.
Pressing START to copy your document to the auto selected
paper. Or, press STOP then select paper manually by using
the [Paper]. And then try again.
. . . or . . .
Document is not set. Set your document.
Check paper size The paper size setting is incorrect.
Check the paper size and set the proper paper size.
Copy protected You tried to use your machine to make a copy, but the
unit’s copy protection feature is on, preventing such use.
Turn off copy protection. (See “Copy protect” on page 4.7)
Enter job hold time. You tried to use the "Last Job" feature, but the "Last Job
hold time" has not been entered. Enter the "Last Job hold
time". (See "Last Job Hold Time" on page 2.28.)
No paper size Your machine does not have suitable sized papers for Mix
is suitable. length copy. To continue, press START and supply the
OK to continue papers the LCD shows. Or, press STOP and select
copying? other ratio.
No paper size There is no paper that matches the reduce/enlarge ratio.
is suitable. Press STOP then select paper manually.
Copying with auto
selected paper.
Not enough memory The copying was stopped because of memory overflow.
The last XXX page Please copy again from indicated page.
was erased.
Please copy again.
Not available with You have set two functions that conflict with each other.
XXXX Cancel either one of the two functions.
Please call service The printer unit of your fax machine has become inopera-
ble. Call your authorized Muratec dealer or Muratec
Customer Support.
Not enough memory. The "Last Job" document cannot be stored due to a
Document was erased. memory shortage.
Rotate document In combine, repeat, series copy or booklet
by 90° or set ratio function, the document is set in the incorrect direction.
Set the document in the rotate by 90° or set the
reduce/enlarge ratio.
Set document in ADF In Booklet copy, you cannot use the FBS glass.
Set your document in ADF for Booklet copies.
Unable to set You cannot set the reduce/enlarge ratio during
ratio during the directional magnification function is used.
D.Mag. is used.
5.11
Just in Case
Getting Started
Troubleshooting