Muratec Fax Machine - Manual (Page 9)

7
Installation
Plug in and power up
1 Plug one end of the telephone line cord into the LINE jack on the machine’s
rear side. Plug the other end of the cord into a standard telephone wall jack,
just as you would plug in a phone.
2 Plug the non-pronged end of the AC power cord into the AC power cord jack
on the rear side of the machine.
3 Plug the pronged end of the AC power cord into a standard electrical outlet.
4 Use the AC power switch to turn on your machine. The markings are interna-
tional standards: I means on, O means off.
Important: BE SURE THAT YOU DO NOT TURN THE POWER ON IF
YOU HAVE NOT REMOVED THE TRANSPORT SCREWS
YET (see step 5 on page 4).
Turn off the transport mode
Important: Be sure you do not turn the power on until after you remove the
transport screws. (See step 5 on page 4.)
To turn off the transport mode:
1 Power up the machine.
The
LCD shows:
2 Press MENU , * , E .
3 Select “OFF” by the cursor key. Then press
[Enter] to turn off the transport mode. The
mirror carriage will move to the home position.
Important: If you must reship the machine to any other location, turn on this
mode to move the mirror carriage to the transport position (in step 3,
above, set the transport mode to ON), then power off and mount the
mirror carriage using the two transport screws.
After the transport mode is set to off, you will see:
Supply paper in cassettes and set the paper size.