Muratec Fax Machine - Manual (Page 48)

Copy settings
02. Width of the separator line
Default setting: 0.01 inch
You can change the width of the separator line in the Combine and Repeat function.
The default setting is 0.01 inch, but you can change it to within 0.01 – 0.05 inch in
0.01 inch steps.
1 Press MENU , [Copy Set].
2 Select “E. User Settings” and then press [Enter].
3 Select “02. Separator Line Width” and then press [Enter].
4 Enter the width of the separator line you want
to set to default.
5 Press [Enter] to save the setting.
6 Press RESET to return to standby.
03. Auto reset mode
Default setting: Auto reset time: 3 minutes, Reset after scan: OFF
The machine returns to its initial condition automatically after a certain period of
time. You can change this time from 1 to 10 minutes. Also, you can set the machine
to return to its initial condition soon after finishing to scan.
Note: The machine first resets the LCD display, and after certain period of time it
resets the key settings to the initial condition.
1 Press MENU , [Copy Set].
2 Select “E. User Settings” and then press [Enter].
3 Select “03. Copy Panel Reset” and then press [Enter].
4 Select “Auto reset time” and then press
[Enter].
5 Enter the time for auto resetting, and then
press [Enter] to save the setting.
6 Select “Reset after scan” and then press
[Enter].
7 Select “ON” or “OFF” then press [Enter] to
save the setting.
8 Press [Exit] to finish.
Press RESET to return to standby.
04. Last Job Hold Time
Default setting: 0 minute
Your machine can hold the last scanned data of copying for a certain period. You can
change that time here.
Note: If it is 0 minute, the Last Job feature will not work.
1 Press MENU , [Copy Set].
2 Select “E. User Settings” and then press [Enter].
3 Select “04. Last Job Hold Time” and then
press [Enter].
4 Enter the time for holding the scanned data for
the Last Job feature.
5 Press [Enter] to save the setting.
6 Press RESET to return to standby.
2.28