Muratec Fax Machine - Manual (Page 122)

Memory transmission
Default setting: ON.
Your fax machine has a great memory! Take advantage of it, and you could:
Save Time. By using your fax machine’s memory, you won’t have to wait for your
machine while it completes the transmission. Simply scan your document into your
fax machine’s memory, and you can walk away with your original in hand.
Save Money. If you’re transmitting to another memory-equipped fax machine, your
machine will send the document directly into the other machine’s memory and hang
up. (The receiving machine then prints out your message from its memory after the
call has ended.) This cuts your actual on-line time to a minimum.
Save Even More Money. Set up a delayed command (see page 3.25) to send your
document after hours, and you can save more money, because the line charges will
be cheaper.
The default transmission mode when the machine is turned on or when modes are
cleared is memory transmission. You can change this setting, see below.
Note: Whether you decide to send your documents from memory or manually, you
can override that choice one transmission at a time by pressing
MEMORY TRANSMIT before you send your document. After completing the
communication, your fax will return to the default setting.
Note: Some documents use up memory more quickly than others. They include
documents with many pages and those with many dark areas. When the
machine’s memory is full, it can transmit only through the document feeder.
Note: When you use the flatbed scanner, the machine always uses memory trans-
mission.
To change the default setting of memory transmission:
1 Press MENU , J , 1, 3, [Enter].
2 Select desired setting using the cursor key.
3 Press [Enter] to save the setting.
If the MEMORY TRANSMIT light glows, memory transmission is on.
If the MEMORY TRANSMIT light doesn’t glow, memory transmission is off.
Quick Memory transmission
Default setting: ON.
Using Quick Memory transmission can save you time over standard memory trans-
missions.
For a normal memory transmission, your fax: (1) scans your entire document into
memory, (2) dials the other fax machine, then (3) transmits the document.
But with Quick Memory transmission, your machine doesn’t wait to scan all pages
into memory before dialing. After it scans the first page of your document, your
machine dials the call. While dialing, connecting and transmitting, your fax
machine continues to scan in the remaining pages of the document.
You can set your fax to always use Quick Memory transmission as the default.
Important: Your fax machine’s memory transmission feature must be turned on
to use Quick Memory transmission (see left column).
To make Quick Memory transmission the default:
1 Press MENU , J , 1, 8, [Enter]. The LCD shows:
2 Select “On” using the cursor key.
3 Press [Enter] to save the setting.
Fax settings
3.70