Muratec Fax Machine - Manual (Page 85)

F
ax F
eatures
Getting Started
Mixed length transmission
When you want to send the various sized documents with the ADF , turn this feature
on.
Note: When you use the FBS glass, you do not need to turn this on.
Acceptable document size
Acceptable document size for the mixed length transmission is as follows:
Half-letter , Letter , Legal
or
Letter , Ledger
To send mixed length documents:
1 Set your documents face up into the ADF .
2 Adjust the document guide to fit the docu-
ments.
3 Press MENU .
4 Select “Mix Length” using the cursor key and
then press [Enter].
5 Adjust resolution, contrast and memory trans-
mission, if necessary.
6 Enter the fax number.
Also, enter any access codes necessary, just as you would for a regular phone
call. (Example: Enter 9 to “dial out” from an office telephone system, or 1 for
long-distance.)
7 Press START .
Important: If you want to cancel a transmission while scanning the docu-
ment, press the STOP key.
If you want to cancel a transmission in progress, use the Job
Review function. (See page 3.29.)
Enlarge transmission
You can transmit your document with enlarging.
Note: Enlargement is available only with the FBS .
Note: You can select a preset enlargement ratio, or directly enter the ratio using
the numeric keypad. Also, you can use cursor key to enter the ratio.
Note: You can enter the enlargement ratio from 100% through 400% in 1% steps.
Here’s how:
1 Place the document on the FBS glass and select resolution and contrast you
require.
2 Press NEXT , [EnlrgeTx].
3 If you want to select area that will be enlarged,
proceed to step 4.
Otherwise, skip to step 5.
4 Press [ScanSize] then select scan size that
will be enlarged.
Then press [Enter].
Note: Refer to “Select scanning area to be
sent,” page 3.2.
5 Enter enlargement ratio.
You can use the
REDUCE / ENLARGE key, or
of the cursor key or numeric keypad to enter
enlargement ratio.
6 Press [Enter].
7 Enter the fax number and press START .
Advanced fax
3.33