Muratec Fax Machine - Manual (Page 54)

3.2
Basic fax
TTI select
When you send a fax message, your TTI is automatically printed at the top of docu-
ments you send. You can select one of three TTI you’ve stored in your machine.
Note: See “EasyStart” on pages 1.17–1.18, to refer the storing the TTI.
To select the TTI:
1 Place the document and select resolution and contrast you require.
2 Press NEXT until [TTI] is appeared on the LCD .
3 Press [TTI].
4 Using a cursor key to select TTI you want to
send.
5 Press [Enter].
6 Dial a fax number.
7 Press START .
Note: After transmission if you did not select TTI before sending a document, the
stored TTI you’ve selected in EasyStart will be printed at the top of docu-
ment you send.
Automatic document size detection
Your machine can automatically detect the following size of your document.
• Letter (8.5
″ ×
11
″
)
• Legal (8.5 ″ × 14 ″ )
• Ledger (11 ″ × 17 ″ )
• Half-letter (5.5 ″ × 8.5 ″ )
Note: Half-letter is available only with the FBS .
If you set the non-standard sized document or the machine could not detect the doc-
ument size, select the scanning size manually. (See the right column.)
Select scanning size to be sent
When you send or store your document, usually the machine automatically detects
the size of your document when it is placed on the
ADF or FBS glass. However, if you
wish to override this and select scanning size manually, proceed to the following
steps.
Note: You can select one of the following standard paper sizes.
•Letter(8.5 ″ × 11 ″ )
•Half-letter(5.5
″ ×
8.5
″
) *
•Legal(8.5 ″ × 14 ″ )
•Ledger(11 ″ × 17 ″ )
* : Half-letter is available only with the FBS .
Note: If you want to set the different sized documents at a time in ADF , turn the
Mix Length feature on. (See page 3.33.)
Note: To override auto document size detection, you have to set the scanning size
at each page scanning.
To select the scanning size manually:
1 Place the document and select resolution and contrast you require.
2 Enter NEXT , [ScanSize].
3 Select desired size by using a cursor key.
Note: When you use the ADF , “H.LTR” will be
shaded and cannot be selected.
4 Press [Enter].
5 Enter the fax number and press START .