Middleby Marshall PS200 series - Manual (Page 35)

34
Page 2 of 10
Controller Types
This Kit includes one Digital Temperature Controller (P/N 46837) that can operate at 120-240V, and
can be programmed to operate in on-off, PID, or variable pulse modes. The Controller is shown in
Figure 1G, below. By following these instructions, the Controller can be installed into any Middleby
Marshall oven equipped with the following Controllers.
• P/N 28071-0012 (Fig. 1A)
Analog Temperature Controller without high-limit and
cooldown functions, operating at 120V, on-off mode only.
• P/N 28071-0018 (Fig. 1A)
Analog Temperature Controller with high-limit and
cooldown functions, operating at 120V, on-off mode only.
• P/N 34983 (Fig. 1B)
Analog Temperature Controller without high-limit and
cooldown functions, operating at 120V, on-off mode only.
Used on PS200VL models. As of 12/01, P/N 34983 is
still available and should be used on these ovens if
possible.
• P/N 28071-0027 (Fig. 1C)
Digital Temperature Controller with blue plastic face-
plate, operating at 120V, on-off mode only.
• P/N 28071-0028 (Fig. 1D)
Digital Temperature Controller with gray rubber face-
plate and buttons with text, operating at 120V, on-off
mode only.
• P/N 28071-0028 (Fig. 1E)
Digital Temperature Controller with gray rubber face
plate and buttons with symbols, operating at 120V, on-
off mode only.
• P/N 30871 (Fig. 1E)
Digital Temperature Controller with gray rubber face
plate and buttons with symbols, operating at 208-240V,
on-off mode only. Used on early PS360WB70 and some
CE oven models.
• P/N 32571 (Fig. 1E)
Digital Temperature Controller with gray rubber face
plate and buttons with symbols, operating at 208-240V,
PID mode only. Used on early PS360EWB.
• P/N 36021 (Fig. 1F)
Digital Temperature Controller with gray face plate (steel
trim on edges), operating at 120-240V, selectable on-
off or PID modes.
• P/N 36056 (Fig. 1G)
Digital Temperature Controller with black plastic face
plate, operating at 120-240V, selectable on-off or PID
modes.
This Kit CANNOT be installed in a PS536 oven equipped with the P/N 44783 (variable pulse electric) or
P/N 44823 (PID gas) controller shown below.
Figure 1
A B
C D E F G
H
SECTION 3 - SERVICING COMPONENTS
Appendix - Instructions for Service Kit 47321 - Digital Temperature Controller Kit, 2/02