Middleby Marshall PS200 series - Manual (Page 8)

7
SECTION 2
AIR FLOW AND HEAT TRANSFER
I. TYPES OF HEAT TRANSFER
Heat constantly moves from a warm object to a cold ob-
ject. Heat moves in three different ways: thorough con-
duction, through radiation, and through convection.
Middleby Marshall conveyor ovens use all three of these
paths to cook the product.
•
Conduction - Heat is transferred through surface con-
tact (such as pizza dough in contact with a pan).
• Radiation - Heat is transferred from light-colored ob-
jects to dark-colored objects. The darker the color of
an object, the greater the amount of heat that it ab-
sorbs. The lighter the color of an object, the greater
the amount of heat that it reflects. Middleby ovens use
light-colored interiors (aluminized or stainless steel,
depending on the oven model) to reflect as much heat
as possible to the product.
• Convection - Heated air will transfer heat to objects
with which it comes into contact. Unless the air flow is
controlled, hot air will rise and be replaced by cooler
air. Middleby Marshall ovens use blowers (one or two
large fans, depending on the oven model) to force air
through adjustable air fingers onto the product.
The intensity of the heat at the point at which it is sensed is
called temperature. The difference in temperature between
the food product and the heat source - that is, the pan,
oven interior, or heated air, as described above - determines
the speed at which the heat flows. The greater the differ-
ence in temperature, the faster the heat flows to the prod-
uct.
In Middleby Marshall conveyor ovens, the heat transfer from
conduction is greatly dependent on the customer’s product
and cooking surface (pans, etc.). Likewise, the heat trans-
fer from radiation is effectively constant, because the color
of the oven interior cannot be changed. For these reasons,
the best way to optimize heat transfer is by regulating the
convection air. This can be done in two ways:
•
Adjusting the blowers and blower speed to change the
quantity and velocity of air delivered onto the product.
• Adjusting the air finger configuration to change the pat-
tern in which the vertical columns of air are delivered to
the product.
II. BLOWERS AND BLOWER SPEED
A. PS200-series ovens
PS200-series ovens have a single blower motor mounted
inside the machinery compartment, with a pulley on
the end of the motor shaft. A belt connects this pulley
to another on the shaft of the blower fan. The air veloc-
ity can be changed by using a larger or smaller pulley
on the motor shaft, and changing the length of the belt
to match the new pulley. See Figure 1.
However, note that there are only two approved belt/
pulley combinations for PS200-series ovens; one for
60Hz ovens, and one for 50Hz ovens. Field modifica-
tions to these approved combinations are not permit-
ted unless under the specific directions of the Middleby
Technical Service Department. Any changes to con-
vection air delivery MUST be made using the air fin-
gers.
SECTION 2 - AIR FLOW AND HEAT TRANSFER
Figure 1
Blowers, belts and pulleys
PS200-series PS360-series PS555/570-series
Current
(PS570S,
PS570G, all
PS555)
Early
(PS570)
Blower Wheel
Orientation
Blower
Wheel
Orientation