Icom IC-7700 - Manual (Page 112)

6-4
■ ∂
∂ TX function
The ∂ TX function shifts the transmit frequency up to
±9.999 kHz in 1 Hz steps (10 Hz steps when cancelling
the 1 Hz step readout) without moving the receive fre-
quency.
q Push .
• “ ” appears.
w Rotate [RIT/ ∂ TX].
e To reset the ∂ TX frequency, push and hold
for 1 sec.
• Push momentarily to reset the ∂ TX frequency
when the quick RIT/ ∂ TX clear function is ON. (p. 12-15)
r To cancel the ∂ TX function, push again.
• “ ” disappears.
D D ∂ ∂ TX monitor function
When the ∂ TX function is ON, pushing and holding
[XFC] allows you to monitor the operating frequency
directly (
∂ TX is temporarily cancelled).
✔
For your convenience— Calculate function
The shift frequency of the ∂ TX function can be
added/subtracted to the displayed frequency.
➥
While displaying the ∂ TX shift frequency, push and
hold for 1 sec.
■
Monitor function
The monitor function allows you to monitor your trans-
mit IF signals in any mode. Use this to check voice
characteristics while adjusting SSB transmit parame-
ter (p. 12-5). The CW sidetone functions regardless of
the switch
setting.
q Push to switch the monitor function ON
and OFF.
• [MONITOR] indicator above this switch lights green.
w Rotate [MONI GAIN] for the clearest audio output
while pushing [PTT] and speaking into the micro-
phone.
NOTE: When using the VOX voice delay, turn the
monitor function OFF; or transmitted audio will be
echoed.
MONITOR
MONITOR
∂ TX
∂ TX
∂ TX
CLEAR
CLEAR
∂ TX
∂ TX [RIT/ ∂ TX]
∂ TX CLEAR
XFC
[MONI GAIN]
MONITOR
6
FUNCTIONS FOR TRANSMIT