Icom IC-7700 - Manual (Page 139)

9-5
■
Fine programmed scan/Fine ∂ F scan
In fine scan (programmed or ∂ F), the scan speed de-
creases when the squelch opens, but the transceiver
keeps scanning. The scanning tuning step shifts from
50 Hz to 10 Hz when the squelch opens.
q Push several times to close a multi-func-
tion screen, if necessary.
w Push [F-5•SCAN] to select the scan screen.
e Set for programmed scan or ∂ F scan as described
on previous page.
r Push [F-1•PROG] or [F-2• ∂ F] to start a scan.
• “ ” or “ ” and decimal
points blink while scanning.
t Push [F-3•FINE] to start a fine scan.
• “ ” or “ ” blinks in-
stead of “ ” or “ ,” respec-
tively.
y When the scan detects a signal, the scan speed de-
creases but scan does not stop.
u Push [F-1•PROG] or [F-2• ∂ F] to stop the scan; push
[F-3•FINE] to cancel the fine scan.
• Rotating the main dial also cancels the scan.
i Push and hold [F-6•RECALL] for 1 sec. to recall the
frequency that is set before starting the scan, if de-
sired.
: F SCAN PROGRAM SCAN
FINE : F SCAN FINE PROGRAM SCAN
: F SCAN PROGRAM SCAN
EXIT/SET
F-2
∂ F
F-3
FINE
F-1
PROG EXIT/SET
9
SCANS