Icom IC-7700 - Manual (Page 166)

12-13
12
SET MODE
■
Others set mode (continued)
Sets the offset (difference between transmit and re-
ceive frequencies) for the quick split function. This set-
ting is used for HF bands in FM mode only and is
used to input the repeater offset for an HF band.
The offset frequency can be set from –9.999 MHz to
+9.999 MHz in 1 kHz steps. (default: –0.100 MHz)
FM SPLIT Offset(HF) –0.100MHz
Sets the offset (difference between transmit and re-
ceive frequencies) for the quick split function. This set-
ting is used for 50 MHz band FM mode only, and is
used to input the repeater offset for the 50 MHz band.
The offset frequency can be set from –9.999 MHz to
+9.999 MHz in 1 kHz steps. (default: –0.500 MHz)
FM SPLIT Offset(50M) –0.500MHz
When this item is ON, the main dial can be used to
adjust the transmit frequency while pushing [XFC]
even while the lock function is activated.
(default: OFF)
See pgs. 6-6, 6-7 for split frequency operation details.
SPLIT LOCK OFF
The internal antenna tuner has an automatic start ca-
pability which starts tuning if the SWR is higher than
1.5–3:1. • OFF : The tuner remains OFF even when the SWR
is poor (1.5–3:1). (default)
• ON : Automatic tune starts even when the tuner is
turned OFF during HF bands operation.
Tuner (Auto Start) OFF
Tuning of the internal antenna tuner can be started
automatically at the moment the PTT is pushed after
the operating frequency is changed (more than 1%
from last-tuned frequency). (default: OFF)
Tuner (PTT Start) OFF