Programmed scan operation, F scan operation – Icom IC-7700 User Manual
Page 138
9-4
■
Programmed scan operation
q
Push
several times to close a multi-func-
tion screen, if necessary.
w
Select VFO mode.
e
Select the desired operating mode.
• The operating mode can also be changed while scan-
ning.
r
Push [F-5•SCAN] to select the scan screen.
t
Set [SQL] open or closed.
• See page 9-2 for squelch condition.
y
Push [F-1•PROG] to start the programmed scan.
• “
” and decimal points blink while
scanning.
u
When the scan detects a signal, scan stops, pauses
or ignores it depending on the resume setting and
the squelch condition.
i
To cancel the scan, push [F-1•PROG].
• Rotating the main dial also cancels the scan.
o
Push and hold [F-6•RECALL] for 1 sec. to recall the
frequency that is set before starting the scan, if de-
sired.
If the same frequencies are programmed into the
scan edge memory channel P1 and P2, pro-
grammed scan will not start.
■ ∂
∂
F scan operation
q
Push
several times to close a multi-func-
tion screen, if necessary.
w
Select VFO mode or a memory channel.
e
Select the desired operating mode.
• The operating mode can also be changed while scan-
ning.
r
Push [F-5•SCAN] to select the scan screen.
t
Set the main band’s [SQL] open or closed.
• See page 9-2 for squelch condition.
y
Set the
∂
F span by pushing [F-4•
∂
F SPAN].
• ±5 kHz, ±10 kHz, ±20 kHz, ±50 kHz, ±100 kHz,
±500 kHz and ±1000 kHz are selectable.
u
Set center frequency of the
∂
F span.
i
Push [F-2•
∂
F] to start the
∂
F scan.
• “
” and decimal points blink while scanning.
o
When the scan detects a signal, the scan stops,
pauses or ignores it depending on the resume set-
ting and the squelch condition.
!0
To cancel the scan, push [F-2•
∂
F].
• Rotating the main dial also cancels the scan.
!1
Push and hold [F-6•RECALL] for 1 sec. to recall the
frequency that was set before starting the scan.
:
F SCAN
EXIT/SET
PROGRAM SCAN
EXIT/SET
[SQL]
Main dial
EXIT/SET
F-1
PROG
[SQL]
Main dial
F-2
∂
F
F-4
∂
F SCAN
EXIT/SET
9
SCANS