Icom IC-7700 - Manual (Page 62)

4-10
D D Contest number set mode
This menu is used to set the contest (serial) number
and count-up trigger, etc.
• Setting contents
q During CW mode operation, push [F-3•KEYER] to
select memory keyer screen.
w Push to select memory keyer menu, then
push [F-3•001] to select contest serial number set
mode.
e Push [F-1• Y ] or [F-2• Z ] to select the desired set
item.
r Set the desired condition using the main dial.
• Push and hold [F-4•DEF] for 1 sec. to select the default
condition or value.
• Contest number set mode screen t Push twice to normal screen. EXIT/SET
EXIT/SET
Main dial
F-1
∫
F-2
√ EXIT/SET
F-4
DEF
4
RECEIVE AND TRANSMIT
This item sets the numbering system used for contest
(serial) numbers— normal or short morse numbers. • Normal : Does not use short morse numbers
(default)
• 190
➔
ANO : Sets 1 as A, 9 as N and 0 as O.
• 190
➔
ANT : Sets 1 as A, 9 as N and 0 as T.
• 90 ➔ NO : Sets 9 as N and 0 as O.
• 90
➔
NT : Sets 9 as N and 0 as T.
This selects which of the four memories will contain
the contest serial number exchange. The count-up
trigger allows the serial number to automatically in-
crement after each complete serial number exchange
is sent. • M1, M2, M3 and M4 can be set. (default: M2)
This item shows the current number for the count-up
trigger channel set above. • Rotate the main dial to change the number, or push
and hold [F-3•001CLR] for 1 sec. to reset the cur-
rent number to 001.
Number Style Normal
Count Up Trigger M2
Present Number 001