Icom IC-7700 - Manual (Page 129)

8-3
8
MEMORY OPERATION
■
Memory channel programming
Memory channel programming can be preformed ei-
ther in VFO mode or in memory mode.
D D Programming in VFO mode
q Set the desired frequency, operating mode and fil-
ter width in VFO mode.
w Push / several times to select the de-
sired memory channel.
• Memory list screen is convenient for selecting the de-
sired channel.
• Memory channel contents appear in the memory chan-
nel readout (below the frequency readout).
• “--.---.--” appears if the selected memory channel is a
blank channel (and does not have contents).
e Push and hold for 1 sec. to program the
displayed frequency, operating mode, etc., into the
memory channel.
D D Programming in memory mode
q Select the desired memory channel with /
in memory mode.
• Memory channel contents appear in the memory chan-
nel readout (below the frequency readout).
• “--.---.--” appears if the selected memory channel is a
blank channel (and does not have contents).
w Set the desired frequency and operating mode in
memory mode.
• To program a blank channel, use direct frequency entry
with the keypad or memo pads, etc.
e Push and hold for 1 sec. to program the
displayed frequency and operating mode into the
memory channel.
MW
√
∫
MW
√ ∫
MW Y Z
or
Push for 1 sec.
Beep
Beep
Beep
MW
SSB
[EXAMPLE]:
Programming 7.088 MHz/LSB into memory channel 12.
or then
Push for 1 sec.
Beep
Beep
Beep
7 21
MW
SSB
[EXAMPLE]:
Programming 21.280 MHz/USB into memory channel 18.