Sunway NT 2600 - Manual (Page 47)

123
EN
Operation of Sunways NT Monitor
After installing the Sunways NT Monitor
software on your PC, you can start the
program. The word «Sunways» will now
appear on your screen.
On the menu bar at the top, you will see
the four menu areas «Program», «Data»,
«Settings» and «Help».
· Setting menu
To configure your solar inverter, open the
«Settings» menu by clicking on it with
the mouse, and click on the «Inverter» key.
Enter the address number that you have
defined for your solar inverter next to
«Inverter». For example, the number «1»
for one solar inverter. In the case of
several units, select «all».
Then enter the desired date and time. The
settings are transferred to the solar inver-
ter by clicking on the «Make change» key.
If you are using several solar inverters and
wish to make a change to the numbering,
you can enter the old number of the
solar inverter in the top section of the
right window half and the new number
beneath it. The numbering is changed
by clicking on the «Make change» key.
Exit the window with the «Close» key.
You will go back to the «Setting» menu.
You can set the interface configuration
with your PC by clicking on the «Connec-
tion» key.
By clicking on the «Remote modem»
key, you can configure an optional modem
(e. g. if you wish to retrieve data by
remote inquiry).
· Data menu
In the «Data» menu, you can call up
the current accumulated performance and
energy of the solar inverter by clicking
on the «Online» key.
You can display the data measured at
15 minute intervals by clicking on the
«Minute values» key. The data and values
are graphically visualised by clicking on
the «Graphic representation» key.