Adding a sun storedge a3500fc array, Adding a fc-tape drive, Removing storage devices – Sun Microsystems FC Switch-8 and Switch-16 816-0830-12 User Manual
Page 154
124
Sun StorEdge Network FC Switch-8 and Switch-16 Installation and Configuration Guide • October 2001
Adding a Sun StorEdge T3 Workgroup or
Enterprise Array
The following applies to when the Sun StorEdge T3 array is connected as a Fabric
device (an array to a switch TL_port and a host port to a switch F_port). If Sun
StorEdge Traffic Manager is enabled, refer to “To Configure a Fabric-Connected
Device as a Sun StorEdge Traffic Manager Device” on page 101. If Sun StorEdge
Traffic Manager is not enabled, refer to “To Configure a Fabric Device” on page 91.
Adding a Sun StorEdge A3500FC Array
Use the
boot -r
command after installing RAID Manager 6.22.1 and the first Sun
StorEdge A3500FC array.
You can add additional Sun StorEdge A3500FC arrays without rebooting, but you
must run the
/usr/lib/osa/bin/hot_add
command.
Adding a FC-Tape Drive
See the following documentation for additional information:
■
For the L180:
■
L180 Operator’s Manual
■
L180 Installation Manual
■
L180 Information Manual
■
L180 Assurance Guide
■
For the L700
■
L700 Operator’s Guide
■
L700 Service Manual
■
L700 Systems Assurance Manual
Removing Storage Devices
This section contains the following topics:
■
“Removing a Sun StorEdge A5200 Array” on page 125
■
“Removing a Sun StorEdge T3 Array Workgroup or Enterprise Configuration” on
page 125
■