Installing the switch – Sun Microsystems FC Switch-8 and Switch-16 816-0830-12 User Manual
Page 76
46
Sun StorEdge Network FC Switch-8 and Switch-16 Installation and Configuration Guide • October 2001
4. Insert the remaining screws through the mounting rail into the cabinet rail.
Do not tighten any of the screws until you have them all loosely started.
5. Tighten all the screws when all four screws in each bracket are in place.
The order of tightening does not matter.
Installing the Switch
▼
To Install the 8-port or 16-port Switch into the
Cabinet
1. From the front of the cabinet, slide the first switch into the lowest of the mounting
rails.
The GigaBit Interface Converter (GBIC) side goes toward the back of the rack. The
switch casing stops moving when it meets the stopper screw on the mounting rail.
2. Insert the front lockdown screws (see
for 8-port switch only).
3. Tighten the stopper screws.