Sun Microsystems FC Switch-8 and Switch-16 816-0830-12 - Manual (Page 72)

42 Sun StorEdge Network FC Switch-8 and Switch-16 Installation and Configuration Guide • October 2001
Attaching the Mounting Rails to the
Expansion Cabinet
The 8-port switch comes with a set of mounting rails that holds two switches. The
16-port switch comes with individual rails for each switch.
This section describes how to attach the mounting rails to an expansion cabinet for
two-switch and four-switch configurations.
“To Attach Mounting Rails for Two 8-port Switches” on page 42
“To Attach Mounting Rails for Four 8- Port Switches” on page 44
Installing the Mounting Rails for 8-Port Switches
▼ To Attach Mounting Rails for Two 8-port
Switches
1. Before you install the rails into the cabinet, loosely start two stopper screws into
each mounting rail. ( FIGURE 4-1 ).
2. Working from the back of the cabinet, loosely start two screws into the cabinet
rails. ( FIGURE 4-1 .)
Refer to the Rackmount Placement Matrix for the locations of the screw holes of your
configuration.