Sun Microsystems FC Switch-8 and Switch-16 816-0830-12 - Manual (Page 67)

Chapter 3 Installation Overview 37
Overview-Installing a New Switch
The following provides the major steps for installing either the 8-port or 16-port
switch hardware and software.
1. Select the area for the expansion cabinet onto which you plan to install the switch.
Be sure to allow for the minimum airflow, temperature, and power restrictions. See
the SANbox-16STD Fibre Channel Switch Installer's/User's Manual for instructions.
2. Verify the configuration for your system.
Supported configurations are detailed in Chapter 2, "Configuration."
Sun StorEdge T3 18Gb disk Firmware 109115-09
VERITAS Volume Manager™ 3.2
VERITAS File System 3.4
Instant Image™ 3.0
fast Write Cache™ 3.0
SNDR 3.0
AP 2.3.1 110722-01
110432-01
StorTools™ 4.1
Sun StorEdge Network Storage Agent™ 2.1
VERITAS NetBackup™ 3.4 110539-04
Solstice Backup™ 6.0
Sun Enterprise 3x00/4x00/5x00/6x00 Flash
prom 3.2.28 103346-29
Sun Fire™ 3800/4800/4810/6800 Flash prom 5.11.6 111346-02
E450 Flash prom 3.22.0 106122-09
E250 Flash prom 3.22.0 106503-06
E420R Flash prom 3.29.0 109082-04
1. After patch 110696-03 is applied, the SANsurfer GUI windows display the package level as 2.08.30.
TABLE 3-1 Minimum Software Component Versions and Patches (Continued)
Non-Bundled Software Minimum Version Minimum Patch