Sun Microsystems FC Switch-8 and Switch-16 816-0830-12 - Manual (Page 156)

126 Sun StorEdge Network FC Switch-8 and Switch-16 Installation and Configuration Guide • October 2001
6. Click remove.
For additional information, see the Sun StorEdge RAID Manager 6.22 User’s Guide.
Removing a FC-Tape Drive
See the following documentation for additional information:
■ For the L180:
■
L180 Operator’s Manual
■
L180 Installation Manual
■
L180 Information Manual
■
L180 Assurance Guide
■ For the L700:
■
L700 Operator’s Guide
■
L700 Service Manual
■
L700 Systems Assurance Manual
Managing Fabric Devices Through
Dynamic Reconfiguration
Devices configured through a Fabric-connected host port are not persistently
configured through dynamic reconfiguration (DR) operations. When you remove a
system component on which Fabric-connected host ports reside, and then add that
system component back to a host through DR operations, the previously-configured
Fabric devices on those host ports are not automatically reconfigured.
In order to maintain persistent Fabric device configuration through DR, Fabric
devices needs to be reconfigured through on-demand node creation in addition to
DR operations.
Before removing a system component through DR operations, you should
unconfigure the Fabric devices that were configured through host ports on the
system component through on-demand node creation.
■ If the Sun StorEdge Traffic Manager software is enabled, refer to “To Unconfigure
a Fabric Device Associated With Sun StorEdge Traffic Manager Devices” on
page 104.
■ If the Sun StorEdge Traffic Manager software is not enabled, refer to “To
Unconfigure a Fabric Device” on page 94.