Sun Microsystems FC Switch-8 and Switch-16 816-0830-12 - Manual (Page 68)

38 Sun StorEdge Network FC Switch-8 and Switch-16 Installation and Configuration Guide • October 2001
3. Install the GBICs.
See the Sun Switch Management Installer's/User's Manual for the 8-port switch, or
the SANbox Segmented Loop Switch User's Manual for instructions.
4. Install the vent panel.
See "Installing the Vent Panel" on page 47.
5. Connect the cables and power cords.
See Chapter 2 for configuration information.
See also "Connecting the Cables" on page 50.
6. Configure the switch for the network.
See Chapter 5 for information on configuring the switch to the network.
7. Install the SANSurfer 3.0 application.
See "Installing the Sun StorEdge Network FC Switch 3.0 GUI" on page 61 for
information on installing the GUI application.
8. Confirm the switch firmware and GUI revision level for your switch.
Refer to TABLE 3-1.
Overview for Software Installations
To install software in your Sun StorEdge Network FC Switch-8 and Switch-16 for
the first time, see “PatchPro™ Interactive” on page 38 and “To Download Patches
Using PatchPro Interactive” on page 39.
To upgrade your software to the Version 3.0 software, see “PatchPro Expert” on
page 39 and “To Download Patches Using PatchPro Expert” on page 40.
PatchPro™ Interactive
Use PatchPro Interactive the first time you install Version 3.0 software. After the
Sun StorEdge Network FC Switch-8 and Switch-16, Version 3.0, software has been
installed, use PatchPro Expert to perform future upgrades to the latest software
revision levels.