Spectra Logic Spectra 12000 - Manual (Page 35)

Chapter 2. Installing the Spectra 12000 Library 35
5. Connect the AC power cord supplied with the Spectra 12000 library
to the AC connector on the rear of the library. Connect the other end
to a 110V AC outlet.
6. Put in the drive sleds, if they are not already installed. See Adding
Drives on page 144 for more information.
7. Go to Turning the Library On and Off on page 36 to power up the
Spectra 12000 library.
Connecting the Ethernet Cables
After you have placed the library carefully and prepared it for operation,
you are ready to connect the Spectra 12000 library to the SAN.
To attach Ethernet connection between the library and the network:
1. Put in the QIP controller cards, if they are not already installed. For
more information on installing QIPs, refer to Adding QIPs on page
149.
2. Attach appropriate fibre optic cables to the Gigabit Ethernet Ports on
the E-QIP.
3. Connect the AC power cord supplied with the Spectra 12000 library
to the AC connector on the rear of the library. Connect the other end
to a 110V AC outlet.
4. Put in drive sleds, if they are not already installed. For more
information on adding drives, refer to Adding Drives on page 144.
5. Go to Turning the Library On and Off on page 36 to power up the
Spectra 12000 library.