Spectra Logic Spectra 12000 - Manual (Page 68)

68 Spectra 12000 User Guide
This chapter will guide you through the installation process for TAOS ITP
and TAOS NDMP, using both interfaces. Both are described in further
detail in the appendices.
Connecting to the Serial Port
Connect a serial cable to the E-QIP diagnostic port, labeled DIAG 1, with a
serial port terminal emulation application like HyperTerminal running on
a host computer. The serial port settings are as follows:
Š Bits per second (BAUD): 115200
Š Data bits: 8
Š Parity: None
Š Stop bits: 1
Š Flow control: None
Figure 7-1 Serial port settings.