Panasonic WJ-HD309 - Manual (Page 10)

10
Please check the documentation supplied with your monitor
to see if your VGA monitor supports a refresh rate of 50 Hz.
If your VGA monitor does not support 50 Hz (or if you are
not sure), then turn off your VGA monitor before turning on
WJ-HD316/WJ-HD309 when using your television as a dis-
play.
o Alarm Connector (ALARM)
Connect an external device such as a sensor or a door
switch with this D-Sub 25-pin connector.
!0 Alarm/Control Connector (ALARM/CONTROL)
Connect a control switch with this D-Sub 25-pin con-
nector when controlling this unit using an external
device, or when controlling an alarm device such as a
buzzer or a lamp.
!1 PS·Data Ports (DATA)
Connect PS·Data compatible devices with these ports.
!2 Mode Switches (MODE)
Set the operation mode of this unit with these dip
switches.
!3 RS485 Ports (RS485 (CAMERA))
Connect RS485 compatible combination cameras with
these ports.
!4 Network Port (10/100BASE-T)
Connect this unit to a network compatible with 10BASE-
T or 100BASE-Tx when controlling this unit using a PC
via a network.
!5 Copy Port (COPY1)
Connect a recommended external recording device to
this port.
!6 Extra Storage Port (EXT STORAGE)
Connect an optional extension unit (WJ-HDE300 series)
with this port.
!7 Power Switch (POWER)
Turns the power of this unit on and off.
!8 Signal Ground Terminal (SIGNAL GND)
!9 Power Cord Inlet (AC IN)
Connect the power cord to this inlet.
■ On Monitor 1 (To display only
live image)
The negative circled numbers indicate the default positions
of camera title
q, time w and event display e.
Important:
• The SETUP MENU will be displayed on monitor 2 and
the VGA monitor. (It is impossible to display the SETUP
MENU on monitor 1.)
• It will take around 2 minutes to display live images on
monitor 1 after turning on the power of the unit.
1. Camera Title
Displays the edited camera title.
A position to display the camera title can be selected
from the following.
Upper left, upper right, lower left, lower right, centre
The default camera title position is lower right (R-
LOWER).
Note: The camera title will be displayed with 16 charac-
ters (2 lines: 8 characters per line).
2. Time
Displays the current time (hour:minute:second) and
date (day:month:year).
A position to display the time can be selected from the
following.
Centre, upper left, lower left, upper right, lower right
The default time display position is upper left (L-
UPPER).
Notes:
• When the camera title and the time display are lay-
ered, only the time display will be displayed.
• When monitor 1 is selected, it is possible to turn
on/off display of the camera title and the time by
pressing the camera selection button 8 for the WJ-
HD316 (the camera selection button 6 for the WJ-
HD309) while the shift function is on (by pressing
the SHIFT button).
q
q q
q
q
w e we
we we