Panasonic WJ-HD309 - Manual (Page 73)

73
■ Connections with the VTR
When it is necessary to copy the recorded images to a video tape using a VTR, connect the VTR to the S-VIDEO connector (or
the VIDEO OUT connector) and the AUDIO OUT connector inside the connectors cover on the front panel of this unit as below.
Note: The same video signal supplied to the MONITOR1 connector and to the MONITOR2 (VGA) connector will be supplied to
the S-VIDEO connector and the VIDEO OUT connector inside the connectors cover.
The same audio signal supplied to the AUDIO OUT connector on the rear panel of this unit will be supplied to the AUDIO
OUT connector inside the connectors cover on the front panel.
VTR
Open the connectors cover.
ALARM
TIMER
HDD 2
ERROR
HDD 1
ALARM
SUSPEND
OPERATE LOGOUT
MONITOR1
MONITOR2
5
9
2
6
10/0
14 13
3
7
11
SHIFT SEQ
COPY DISK SELECT
EL-ZOOM
TEXT
LOGOUT
4
8
12
OSD
MARK
1
15 16
BUSY
REV FWD
STOP PLAY PAUSE REC - REC STOP
SEARCH
SETUP
/ESC
PAN/TILT
SLOW A-B
REPEAT
GOTO
LAST
LISTED
ZOOM/
FOCUS
IRIS
PRESET
/AUTO
SET
– + ALARM
RESET
S-VIDEO
COPY 2 VIDEO OUT
AUDIO
OUT
PAN/
TILT
AUDIO
IN
S-VIDEO IN
connector
Audio cable with an RCA pin plug (Locally procured)
Audio cable with an RCA pin plug (Locally procured)
S-video cable (Locally procured)
VIDEO
IN