Panasonic WJ-HD309 - Manual (Page 85)

85
● Connection for the Auto Adjust Time function
• When "Auto Adjust Time" of "System" on the SETUP MENU is set to "MASTER"
"Time Adjust Output" becomes available and the clock of this unit can be applied to other units.
• When "Auto Adjust Time" of "System" on the SETUP MENU is set to "SLAVE"
"Time Adjust Input" becomes available. When a signal output from other equipment is supplied to the time adjust I/O terminals
between 00 minutes 00 seconds and 14 minutes 59 seconds every hour or between 45 minutes 00 seconds and 59 minutes
59 seconds every hour, the clock will be set to "00 minutes 00 seconds" of the closest hour.
Example:
Signal is supplied at 2:50:00 (hour:minute:second)pm
→ Set at 3:00:00 pmM
Signal input supplied at 3:14:45 pm → Set at 3:00:00 pm
Signal is supplied at 3:20:00 pm → Time will not be adjusted.
Important:
Recording will not be performed for around 4 seconds when changing the present time (accurate within ±5 seconds) using
the time adjustment input (pin no.20).
Terminal block of other units
(Time adjust output)
(Earth)
ALARM/CONTOROL
Earth Sensor input Alarm input Alarm reset input Series recording input Time adjust input Earth Alarm output Alarm reset output Alarm recording During recording Disk Buzzer output System error output Temperature error output Time adjust output Series recording output
!3 @0
Front LED
monitor
output
ALARM/CONTOROL
Terminal block of other units
Earth Sensor input Alarm input Alarm reset input Series recording input Time adjust input Earth Alarm output Alarm reset output Alarm recording During recording Disk Buzzer output System error output Temperature error output Time adjust output Series recording output
Front LED
monitor
output
(Time adjust output)
(Earth)
!3 @0