Panasonic WJ-HD309 - Manual (Page 16)

16
z
Insert the power plug to an outlet (AC 220 V -
240 V, 50 Hz)
Note: Make sure the power source is AC 220 V - 240 V,
50 Hz.
x
Turn on the power switch on the rear panel.
The OPERATE indicator will light and the system check
(checking the system and hard disk) will start.
The startup splash image below will be displayed on moni-
tor 2 and the VGA monitor during the system check.
When the auto login is off, the login window will be dis-
played if any button on the front panel of this unit is pressed
after the system check. (Go to step 3)
When the auto login is on, live images will be displayed
after the system check.
Notes:
• If the hard disk configuration was changed after the last
startup or the hard disk has problems, the HDD DISK
MENU will be displayed automatically after the startup
splash. (Refer to page 131 for further information.)
• It is possible to display the disk configuration menu by
pressing the SET button when the image displayed
below that says the system check has been completed.
Important:
When using the optional extension unit (WJ-HDE300
series), turn on the power of this unit after turning on the
power of all extension units.
c
Enter a user name and password.
Rotate the jog dial to select a character to be entered in the
cursor position.
It is also possible to enter numbers by pressing the camera
selection buttons ([1] - [10/0] for the WJ-HD316, [1] - [9],
[0] for the WJ-HD309).
To move the cursor, press the arrow buttons.
Use the same method to enter or edit characters attached
to images. Refer to page 54 for further information.
Notes:
• The default user name and password are as follows:
User name: ADMIN
Password: 12345
• To enhance the security, change the password for an
administrator before starting to run the unit. It is recom-
mended to change the password for an administrator
periodically.
• To log out, press the LOGOUT button after confirming
that the SHIFT indicator is lit.
v
Display a live image.
Press the SET button to display a live image.
If the authentication (login) window is displayed, enter the
user name and password.
When authenticated, a live image will be displayed.
When not authenticated, the authentication (login) window
will be displayed again.
STARTUP