Panasonic WJ-HD309 - Manual (Page 34)

34
⁄0
Select the sensitivity using the arrows button
(D C) from the following.
OFF: Motion will not be detected
LOW: Low sensitivity
MID: Standard sensitivity
HIGH: High sensitivity
⁄1
Rotate the jog dial to select "EXIT" on the sta-
tus bar to exit from the motion detection area
setup window.
m
Move the cross cursor using the arrows button
to a point to be determined as the end point of
the motion detection area.
Press the SET button to determine the selected point as the
end point of the motion detection area.
It is possible to set up to 4 motion detection areas by
repeating steps 6 and 7.
,
Rotate the jog dial to select "SENSITIVITY" on
the status bar.
Note: Depending on the position of the set detection areas,
the sensitivity indications of the detection areas may be
displayed overlapping each other.
.
Move the cross cursor to the motion detection
area to apply the sensitivity using the arrows
button (A B).
R
2
R
1
LOGOUT
MONITOR1
MONITOR2
5
9
2
6
10/0
14 13
3
7
11
SHIFT SEQ
COPY DISK SELECT
EL-ZOOM
TEXT
LOGOUT
4
8
12
OSD
MARK
1
15 16
BUSY 316
REV FWD
STOP PLAY PAUSE REC - REC STOP
SEARCH
SETUP
/ESC
PAN/TILT
SLOW A-B
REPEAT
GOTO
LAST
LISTED
ZOOM/
FOCUS
IRIS
PRESET
/AUTO
SET
– +
PAN/
TILT
m , ⁄1 m.⁄0